Krone EasyCut F 360 User Manual

2 Safety
2.4 Basic safety instructions
16
EasyCut F 320 M
Original Operating Instructions 150000808_01_en
Technical limit values
If the technical limit values of the machine are not observed, the machine may be damaged. As
a result, accidents may occur and people may be seriously injured or killed. Observance of the
following technical limit values is particularly important for safety:
• Maximum permissible operating pressure of hydraulics
• Maximum permissible drive speed
• Maximum permissible axle loads of tractor
 Observe the limits, refer to page32.
2.4.10 Danger zones
If the machine is switched on, its surrounding can present a danger zone.
Avoid entering the danger zone of the machine by observing the minimum safety distance.
If the safety distance is not observed, people may be seriously injured or killed.
 Do not switch on the drives and engine if the minimum safety distance has not been
observed.
 If people fail to observe the minimum safety distance, switch off the drives.
 Switch the machine off in shunting and field mode.
The safety distance is:
For machine in shunting operation and field mode
In front of the machine 30m
Behind the machine 5m
Laterally to the machine 3m
For machine switched on without driving motion
In front of the machine 3m
Behind the machine 5m
Laterally to the machine 3m
The safety distances specified here are minimum distances in terms of intended use. If
necessary, these safety distances must be increased according to the operating and ambient
conditions.
 Before working in front of and behind the tractor and in the danger zone of the machine:
Shut down and secure the machine, refer to page24. This also applies to brief inspection
work.
 Consider the information in all relevant operating instructions:
• The operating instructions of the tractor
• The operating instructions of the machine
• The operating instructions of the universal shaft
Danger zone universal shaft
People may become caught by the universal shaft, pulled in and seriously injured.
 Observe operating instructions of universal shaft.
 Ensure sufficient overlap of section tube and universal shaft guards.
 Make sure that the universal shaft guards are mounted and that they are fully functional.
 Allow the universal shaft locks to engage.

Krone EasyCut F 360 Specifications

General

Brand	Krone
Model	EasyCut F 360
Category	Lawn Mower
Language	English