Krone EasyCut F 360 User Manual

Safety 2
Basic safety instructions 2.4
EasyCut F 320 M
Original Operating Instructions 150000808_01_en 23
2.4.19 Dangers in connection with certain activities: Working on the machine
Only perform work when the machine is at standstill
If the machine is not shut down and safeguarded, parts may move unintentionally or the
machine may start moving. Thus there is a risk of serious injuries or death.
 Before carrying out any repair, maintenance and cleaning work on the machine, shutdown
and safeguard it, refer to page24.
Maintenance and repair work
Improper maintenance and repair work endanger operational safety. Thus there is a risk of
accidents, serious injuries or death.
 Only perform work which is described in this operating instructions. Prior to any work, stop
and safeguard the machine, refer to page24.
 All other maintenance and repair work must only be performed by qualified specialist
workshop.
Raised machine and machine parts
The raised machine and machine parts may fall or tilt unintentionally. People may be seriously
injured or killed, as a result.
 Do not stay under the raised machine or machine parts which are not safely supported, refer
to page24.
 Prior to all work on raised machines or machine parts, lower the machine or machine parts.
 Before performing any work under raised machines or machine parts, secure the machine or
machine parts with rigid safety support or with hydraulic shut-off device or by supporting
against lowering.
Danger associated with welding work
Improper welding work will endanger the operational safety of the machine. As a result,
accidents may occur and people may be seriously injured or killed.
 Never perform welding work on the following components:
• Gearboxes
• Components of the hydraulics
• Components of the electronics
• Frame or supporting components
• Running gear
 Before carrying out welding work on the machine, obtain consent by KRONE customer
service and, if required, identify alternatives.
 Before performing welding work on the machine, park the machine safely and disconnect it
from the tractor.
 Have welding work performed by experienced technicians only.
 Attach the earthing of the welding device near the welding points.
 Caution when performing welding work near electric and hydraulic parts, plastic parts and
pressure accumulators. The parts may be damaged, endanger people or cause accidents.

Krone EasyCut F 360 Specifications

General

Brand	Krone
Model	EasyCut F 360
Category	Lawn Mower
Language	English