11 Maintenance - General Information
11.1 Maintenance table
58
EasyCut F 320 M
Original Operating Instructions 150000808_01_en
11 Maintenance - General Information
WARNING
Risk of injury due to non-observance of relevant safety instructions
If the relevant safety instructions are not observed, persons may be seriously injured or killed.
To avoid accidents, the relevant safety instructions must be read and observed, refer to
page13.
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
The safety routines must be read and observed to avoid accidents, refer to page24.
WARNING
Risk of injury caused by test run of the machine
If a test run is performed after repair, maintenance or cleaning work or after technical
intervention, the machine may behave unpredictably. Thus there is a risk of serious injuries or
death.
ü The machine is in working position.
Do not switch on the drives until the mower is resting on the ground and you are
absolutely sure that there is no one in the danger zone.
The test run of the machine must only be started from the driver's seat.
11.1 Maintenance table
11.1.1 Maintenance - Once after 50 hours
Changing oil
Input gearbox refer to page66
Main gearbox refer to page67
11.1.2 Maintenance - Before the beginning of the season
Checking oil level
Input gearbox refer to page66
Main gearbox refer to page67
Cutterbar refer to page79
Components
Changing/replacing blades refer to page71
Check/replace cutting discs/mower drums refer to page77
Check/replace retaining bolt (blade screw con-
nection)
refer to page74
To Next Page
Loading...
Need help?
General
