Krone EasyCut F 360 User Manual

Maintenance - General Information 11
Deviating tightening torques 11.3
EasyCut F 320 M
Original Operating Instructions 150000808_01_en 63
*)Always replace copper rings
11.3 Deviating tightening torques
Screws/nuts Tightening torque
Nut for shear protection (rotary hub) 300 Nm
Bearing housing for cutting disc 55 Nm
Bearing housing for mower drum 55 Nm
11.4 Venting the friction clutch
NOTICE
Interventions in the friction clutch will lead to a loss of guarantee!
Interventions in the friction clutch change the slip torque. Therefore the machine may be
damaged considerably.
 Never intervene in the overload protection.
 Only use KRONE original spare parts.
The friction clutch protects the tractor and the machine from damage. The friction clutch must be
vented before starting up for the first time and once a year. The friction clutch is designed with a
permanently adjusted turning torque M
R
. The torque is applied to the housing of the friction
clutch (2).
Venting friction clutch (Walterscheid)
KM000-072
ü The machine is in the working position, refer to page48.
ü The machine is shut down and safeguarded, refer to page24.
 Remove the universal shaft.
 Tighten the nuts (1) evenly.
ð The friction discs are relieved.
 Turn the friction clutch (2).
 Turn the nuts (1) back as far as the thread run-out.

Krone EasyCut F 360 Specifications

General

Brand	Krone
Model	EasyCut F 360
Category	Lawn Mower
Language	English