Safety 2
Safety Labels on the Machine 2.6
EasyCut F 320 M
Original Operating Instructions 150000808_01_en 25
In order to safely support the machine or machine parts:
To support, only use suitable and sufficiently dimensioned materials that do not break or
yield.
Bricks and hollow blocks are not suitable for safely supporting the machine and machine
parts. Therefore they must not be used.
Car jacks are also not suitable for safely supporting the machine and machine parts. They
must not be used, as well.
2.5.3 Carrying out oil level check and oil and filter element changes safely
WARNING
Carrying out oil level check and oil and filter element changes safely
If oil level check and oil and filter element changes are not carried out safely, the operational
safety of the machine may be impaired. This may result in accidents.
Carry out oil level check and oil and filter element changes safely.
To carry out oil level check, oil and filter element changes safely:
Lower raised machine parts or secure them against falling, refer to page24.
Shut down and safeguard the machine, refer to page24.
Observe the intervals for oil level check, oil and filter element changes, refer to page58.
Use only the oil grades and quantities specified in the consumables table, refer to page32.
Clean the area around the parts (for example gearbox, high-pressure filter) and make sure
that no foreign objects get into the parts or the hydraulic system.
Check existing seal rings for damage and replace them, if necessary.
Collect leaking or waste oil in a container designated for the purpose and dispose of it
properly, refer to page20.
2.6 Safety Labels on the Machine
Every safety label is provided with an order number and can be ordered directly from the
authorised KRONE dealer. Immediately replace missing, damaged and unrecognisable safety
labels.
When attaching safety labels, the contact surface on the machine must be clean and free of dirt,
oil and grease to ensure optimum adhesion of the labels.
To Next Page
Loading...
Need help?
General
