Special equipment
74
Pos: 29.1 /Übersc hriften/Übersc hriften 1/P-T/Son derausstattu ng @ 2\mod_120 2808469779_ 78.docx @ 61649 @ 2 @ 1
14 Special equipment
Pos: 29.2 /Übersc hriften/Übersc hriften 2/P-T/Spezi elle Sicher heitshinweise @ 0\mod_11966604 95760_78.doc x@ 9134 @ @ 1
14.1 Special Safety Instructions
Pos: 29.3 /BA/Sich erheit/Gefahr enhinweise/M ähwerke/Gefahr - Re paratur_Wart ung_Reinigu ngs_4 allgemei nE asyCut @ 1 1\mod_12236201 98301_78.doc x @ 148349 @ 2@ 1
Danger! - When performing repair, maintenance or cleaning work on the machine, or in
the case of technical intervention, drive elements may start moving (caution, the cutting
discs continue to run).
Effect: Danger to life, injuries or damage to the machine.
• Move the machine to the working position and lower it to the ground
• Switch off the tractor engine and remove the ignition key.
• Secure the tractor against accidental start-up and against rolling.
• Switch off the PTO and disengage it.
• After repair, maintenance, cleaning work or technical modifications are complete, mount
all protective coverings and safety devices again properly.
• Avoid skin contact with oils, greases, cleaning agents and solvents.
• In the event of injuries or burns due to oils, cleaning agents or solvents, contact a doctor
immediately.
• All other safety instructions must also be followed to avoid injuries and accidents.
Pos: 29.4 /BA/Son derausstatung/ EasyCut / AM M ähwerke/Hoc hschnittkufen E asyCut @ 3\m od_1204783761 105_78.doc x@ 72974 @ @ 1
14.2 Adjusting Skids
1
3
EC-192-1
2
Fig. 44
Adjusting skids can be used to increase the cutting height (see chapter entitled "Adjusting the
cutting height")
To do this, insert the adjusting skids (3) into the glide skids (2) and screw them in place. The
adjusting skids must always be mounted underneath the mowing discs that run next to the
mower drum.
Pos: 30 /BA/----- ---------- Seitenumbruch------ ---------- @ 0\mod_1 19617531122 6_0.docx @ 41 65@ 1 @ 1
To Next Page
Loading...
Need help?
General
