15 ELECTRICAL SYSTEM 144
15.10 Changing the parking light bulb
Note
Damage to reflector Reduced brightness.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
Preparatory work
– Switch off the ignition by turning the ignition key to the position .
– Remove the headlight mask with the headlight. ( p. 138)
V00071-10
Main work
–
Pull cable sleeve
and the socket of parking light
carefully out of the housing.
– Remove the bulb.
– Position a new light bulb in the socket.
Parking light (W5W / socket W2.1x9.5d) ( p. 182)
–
Carefully position socket
with the bulb in the housing.
–
Mount cable sleeve
.
Finishing work
– Install the headlight mask with the headlight. ( p. 139)
– Check the headlight setting. ( p. 146)
To Next Page
Loading...
Need help?
General
