20 STORAGE 170
– Lift the motorcycle with the front lifting gear. ( p. 84)
– Cover the motorcycle with a porous sheet or blanket.
Info
Do not use non-porous materials since they prevent humidity from escaping,
thus causing corrosion.
Avoid running the engine for a short time only. Since the engine cannot warm
up properly, the water vapor produced during combustion condenses and causes
valves and exhaust system to rust.
20.2 Preparing for use after storage
401059-01
– Take the motorcycle from the front lifting gear. ( p. 85)
– Remove the rear of the motorcycle from the lifting gear. ( p. 83)
– Recharge the battery. ( p. 129)
– Install the battery. ( p. 128)
– Set the time and date. ( p. 49)
– Perform checks and vehicle care when preparing for use. ( p. 56)
– Take a test ride.
To Next Page
Loading...
Need help?
General
