18 SERVICE WORK ON THE ENGINE
140
K00573-10
– Lay the motorcycle on its right side and fill the oil filter hous-
ing approx. ⅓ full with engine oil.
– Place the oil filter into the oil filter housing.
– Oil the O-ring of the oil filter cover and mount it together with
oil filter cover
7
.
– Mount and tighten the screws.
Guideline
Screw, oil filter cover M6 10 Nm (7.4 lbf ft)
– Stand the motorcycle upright.
401955-12
–
Remove filler plug
8
from the clutch cover together with the
O-ring, and fill up with engine oil.
Engine oil 1.0 l (1.1 qt.) Engine oil
(SAE 10W/50)
( p. 159)
Info
Too little engine oil or poor-quality engine oil will result
in premature wear of the engine.
– Mount and tighten the filler plug together with the O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
– Always make sure there is sufficient ventilation
when running the engine.
– Use effective exhaust extraction when starting or
running the engine in an enclosed space.
– Start the engine and check it for leaks.
Finishing work
(EXC‑F Six Days)
– Install the engine guard. ( p. 93)
– Check the engine oil level. ( p. 138)
18.4 Adding engine oil
Info
Too little engine oil or poor-quality engine oil will result in premature wear of the engine.
To Next Page
Loading...
Need help?
General
