To Next Page

To Previous Page

29 LIST OF SYMBOLS

167

29.1 Yellow and orange symbols

Yellow and orange symbols indicate an error condition that requires prompt intervention. Active driving aids are

also represented by yellow or orange symbols.

Malfunction indicator lamp lights up/flashes yellow – The OBD has detected a fault in the

vehicle electronics. Come safely to a halt, and contact an authorized KTM workshop.

The fuel level warning lamp lights up yellow – The fuel level has reached the reserve mark.

29.2 Green and blue symbols

Green and blue symbols reflect information.

The high beam indicator lamp lights up blue – The high beam is switched on.

Turn signal indicator lamp flashes green – The turn signal is switched on.

Default Chapter4
- Table of Contents4
1 Means of Representation8
- Symbols Used8
- Formats Used8
2 Safety Advice9
- Use Definition - Intended Use9
- Misuse9
- Degrees of Risk and Symbols9
- Tampering Warning10
- Safe Operation10
- Protective Clothing11
- Work Rules11
- Environment11
- Owner's Manual11
3 Important Notes12
- Manufacturer and Implied Warranty12
- Operating and Auxiliary Substances12
- Spare Parts, Accessories12
- Service12
- Figures12
- Customer Service13
4 View of Vehicle14
- View of Vehicle, Front Left (Example)14
- View of Vehicle, Rear Right (Example)15
5 Serial Numbers16
- Chassis Number16
- Type Label16
- Key Number16
- Engine Number16
- Fork Part Number17
- Shock Absorber Article Number17
6 Controls18
- Clutch Lever18
- Hand Brake Lever18
- Throttle Grip18
- Kill Switch18
- Horn Button19
- Light Switch19
- Turn Signal Switch19
- Emergency off Switch19
- Electric Starter Button20
- Combination Switch (EXC-F Six Days)20
- Indicator Lamps Overview20
- Opening the Filler Cap21
- Closing the Filler Cap21
- Cold Start Button22
- Idle Speed Adjusting Screw22
- Shift Lever23
- Foot Brake Lever23
- Side Stand23
- Steering Lock24
- Locking the Steering24
- Unlocking the Steering25
7 Combinationinstrument26
- Combination Instrument26
- Combination Instrument Overview26
- Activation and Test26
- Setting the Kilometers or Miles26
- Adjusting the Combination Instrument27
- Setting the Clock28
- Viewing the Lap Time28
- Display Mode SPEED (Speed)29
- Display Mode SPEED/H (Operating Hours)29
- Setup Menu29
- Setting the Unit of Measurement30
- Display Mode SPEED/CLK (Time)31
- Setting the Clock31
- Display Mode SPEED/LAP (Lap Time)31
- Viewing the Lap Time32
- Display Mode SPEED/ODO (Odometer)32
- Display Mode SPEED/TR1 (Trip Master 1)33
- Display Mode SPEED/TR2 (Trip Master 2)33
- Setting TR2 (Trip Master 2)33
- Display Mode SPEED/A1 (Average Speed 1)34
- Display Mode SPEED/A2 (Average Speed 2)34
- Display Mode SPEED/S1 (Stop Watch 1)35
- Display Mode SPEED/S2 (Stop Watch 2)35
- Table of Functions36
- Table of Conditions and Menu Activation37
8 Preparing for Use38
- Advice on First Use38
- Running-In the Engine39
- Starting Power of Lithium-Ion Batteries at Low Temperatures (All EU/AU Models)40
- Preparing the Vehicle for Difficult Riding Conditions40
- Preparing for Rides on Dry Sand41
- Preparing for Rides on Wet Sand41
- Preparing for Rides on Wet and Muddy Surfaces42
- Preparing for Rides at High Temperature and Slow Speed42
- Preparing for Rides at Low Temperature or in Snow43
9 Riding Instructions44
- Checks and Maintenance Measures When Preparing for Use44
- Starting the Vehicle44
- Activating Traction Control (EXC-F Six Days)45
- Starting off46
- Shifting, Riding46
- Braking47
- Stopping, Parking47
- Transporting48
- Refueling48
10 Service Schedule50
- Additional Information50
- Required Work50
- Recommended Work51
11 Tuning the Chassis52
- Checking the Basic Suspension Setting against the Rider's Weight52
- Compression Damping of the Shock Absorber52
- Adjusting the Low-Speed Compression Damping of the Shock Absorber52
- Adjusting the High-Speed Compression Damping of the Shock Absorber53
- Adjusting the Rebound Damping of the Shock Absorber54
- Measuring the Rear Wheel Dimension Unloaded54
- Checking the Static Sag of the Shock Absorber55
- Checking the Riding Sag of the Shock Absorber55
- Adjusting the Spring Preload of the Shock Absorber56
- Adjusting the Riding Sag57
- Checking the Basic Setting of the Fork57
- Adjusting the Compression Damping of the Fork58
- Adjusting the Rebound Damping of the Fork59
- Adjusting the Spring Pretension of the Fork (EXC-F Six Days)60
- Handlebar Position61
- Adjusting the Handlebar Position61
12 Service Work on the Chassis64
- Raising the Motorcycle with the Lift Stand64
- Removing the Motorcycle from the Lift Stand64
- Bleeding the Fork Legs64
- Cleaning the Dust Boots of the Fork Legs65
- Removing the Fork Protector65
- Installing the Fork Protector66
- Removing the Fork Legs66
- Installing the Fork Legs67
- Removing the Lower Triple Clamp (EXC-F EU/AU/BR)68
- (EXC-F Six Days)69
- Installing the Lower Triple Clamp (EXC-F EU/AU/BR)70
- Installing the Lower Triple Clamp (EXC-F Six Days)72
- Checking the Play of the Steering Head Bearing74
- Adjusting the Steering Head Bearing Play (EXC-F EU/AU/BR)75
- Adjusting the Steering Head Bearing Play (EXC-F Six Days)75
- Lubricating the Steering Head Bearing76
- Removing Front Fender76
- Installing Front Fender77
- Removing the Shock Absorber78
- Installing the Shock Absorber78
- Removing the Seat79
- Mounting the Seat79
- Removing the Air Filter Box Cover79
- Installing the Air Filter Box Cover80
- Removing the Air Filter80
- Installing the Air Filter81
- Cleaning the Air Filter and Air Filter Box81
- Sealing the Air Filter Box82
- Securing the Air Filter Box Cover82
- Removing Main Silencer83
- Installing the Main Silencer83
- Changing the Glass Fiber Yarn Filling in the Main Silencer83
- Removing the Fuel Tank84
- Installing the Fuel Tank86
  - Checking for Chain Dirt Accumulation87
  - Cleaning the Chain87
  - Checking the Chain Tension88
  - Adjusting the Chain Tension89
  - Checking the Chain, Rear Sprocket, Engine Sprocket and Chain Guide90
  - Checking the Frame93
  - Checking the Swingarm93
  - Checking Throttle Cable Routing93
  - Checking the Rubber Grip94
  - Adjusting the Basic Position of the Clutch Lever94
  - Checking/Correcting the Fluid Level of the Hydraulic Clutch95
  - Changing the Hydraulic Clutch Fluid96
  - Removing the Engine Guard (EXC-F AU, EXC-F Six Days)97
  - Installing the Engine Guard (EXC-F AU, EXC-F Six Days)97
13 Brake System98
- Checking the Free Travel of the Hand Brake Lever98
- Adjusting Free Travel of Hand Brake Lever98
- Checking the Brake Discs98
- Checking the Brake Fluid Level of the Front Brake99
- Adding Front Brake Fluid100
- Checking the Front Brake Linings101
- Changing the Front Brake Linings101
- Checking the Free Travel of Foot Brake Lever103
- Adjusting the Basic Position of the Foot Brake Lever104
- Checking the Rear Brake Fluid Level105
- Adding Rear Brake Fluid105
- Checking the Rear Brake Linings106
- Changing the Rear Brake Linings107
14 Wheels, Tires110
- Removing the Front Wheel110
- Installing the Front Wheel111
- Removing the Rear Wheel111
- Installing the Rear Wheel112
- Checking the Tire Condition114
- Checking the Tire Air Pressure114
- Checking Spoke Tension115
15 Electrical System116
- Removing the Battery116
- Installing the Battery117
- Recharging the Battery118
- Changing the Main Fuse121
- Changing the Fuses of Individual Power Consumers122
- Removing the Headlight Mask with the Headlight124
- Installing the Headlight Mask with the Headlight124
- Changing the Headlight Bulb125
- Checking the Headlight Setting126
- Adjusting the Headlight Range126
- Changing the Turn Signal Bulb127
- Changing the Combination Instrument127
- Diagnostics Connector128
16 Cooling System129
- Checking the Antifreeze and Coolant Level129
- Checking the Coolant Level130
- Draining the Coolant131
- Refilling Coolant132
17 Tuning the Engine133
- Checking the Play in the Throttle Cable133
- Adjusting the Play in the Throttle Cable133
- Setting the Characteristic Map of the Throttle Response134
- Changing the Mapping (EXC-F Six Days)135
- Adjusting the Idle Speed136
- Teaching the Throttle Valve Position137
- Checking the Basic Position of the Shift Lever137
- Adjusting the Basic Position of the Shift Lever138
18 Service Work on the Engine139
- Changing the Fuel Screen139
- Checking the Engine Oil Level140
- Changing the Engine Oil and Oil Filter, Cleaning the Oil Screen140
- Adding Engine Oil143
19 Cleaning, Care144
- Cleaning the Motorcycle144
- Checks and Maintenance Steps for Winter Operation145
20 Storage146
- Preparing for Use after Storage147
21 Troubleshooting148
22 Blink Code151
23 Technical Data153
- Engine153
- Engine Tightening Torques154
- Capacities156
- Engine Oil156
- Coolant156
- Fuel156
- Chassis156
- Electrical System157
- Tires158
- Fork158
- Exc-F Eu/Au/Br158
- EXC-F Six Days158
- Shock Absorber159
- Chassis Tightening Torques160
24 Substances162
25 Auxiliary Substances164
26 Standards166
27 Index of Special Terms167
28 List of Abbreviations168
29 List of Symbols169
- Yellow and Orange Symbols169
- Green and Blue Symbols169
- Index170

Brand	KTM
Model	250 EXC-F EU 2018
Category	Motorcycle
Language	English

KTM 250 EXC-F EU 2018 User Manual

Table of Contents

Other manuals for KTM 250 EXC-F EU 2018

Questions and Answers:

KTM 250 EXC-F EU 2018 Specifications

Related product manuals