25OPERATING THE MACHINE
ENGLISH
STOPPING
BStopping
1. Slow down the engine.
2. Step on the brake pedal.
3. After the machine has stopped, disengage the PTO,
lower the implement to the ground and set the parking
brake.
CHECK DURING DRIVING
BImmediately Stop the Engine if:
A The engine suddenly slows down or accelerates.
A Unusual noises suddenly occur.
A Exhaust fumes suddenly become very dark.
While driving, make the following checks to see that all the
parts are functioning normally.
BEasy Checker (TM)
If the warning lamps in the Easy Checker(TM) come on
during operation, stop the engine immediately, and find
the cause as shown below.
Never operate the machine while Easy Checker(TM) lamp
is "ON".
: Engine oil pressure
If the oil pressure in the engine goes below the
prescribed level, the warning lamp in the Easy
Checker(TM) will come on.
If this should happen during operation, and it does
not go off when the engine is accelerated to more
than 1000 rpm, check the level of engine oil.
(See "Checking Engine Oil Level" in "DAILY CHECK"
in "PERIODIC SERVICE" section.)
: Electrical charge
If the alternator is not charging the battery, the warning
lamp in the Easy Checker(TM) will come on.
If this should happen during operation, check the
electrical charging system or consult your local
KUBOTA Dealer.
: Glow plug indicator (Pre-heating Indicator)
When the key switch is in the "PREHEAT" position, the
glow plug indicator illuminates.
A For checking and servicing of your machine, consult
your local KUBOTA Dealer for instruction.
(1) Easy Checker(TM)
(2) Fuel gauge
(3) Coolant temperature gauge
To Next Page
Loading...
Need help?
General
