PERIODIC SERVICE48
ENGLISH
BChecking Engine Oil Level
To avoid personal injury:
A Be sure to stop the engine before checking the
oil level.
1. Park the machine on a flat surface.
2. Check engine oil before starting the engine or 5
minutes or more after the engine has stopped.
3. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies between the two notches.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
A When using an oil of different maker or viscosity from
the previous one, remove all of the old oil and oil filter.
Never mix two different types of oil.
A If oil level is low, do not run the engine.
Starting the
engine
1
Color of the exhaust
fumes
-
2
Safety start switch, seat
safety control and
another safety devices.
If either of these do not
operate properly,
contact your local
KUBOTA Dealer
immediately.
51
3
Check for abnormal
noise and vibration.
-
Others 1
Check the areas where
previous trouble was
experienced.
-
No. Check item
Ref.
Page
(1) Oil inlet (A) Oil level is acceptable within this range
(2) Dipstick
To Next Page
Loading...
Need help?
General
