Kubota G23-2 User Manual

PERIODIC SERVICE68
ENGLISH
BReplacing Engine Oil Filter
To avoid personal injury:
A Be sure to stop the engine and remove the key
before changing the oil and the oil filter.
A Allow engine to cool down sufficiently; oil can
be hot and may cause burns.
1. [Model with the engine filter cover]
Remove the engine filter cover.
2. Remove the oil filter.
3. Put a film of clean engine oil on the rubber seal of the
new filter.
4. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
5. After new filter has been replaced, the engine oil
normally decreases a little. Make sure that the engine
oil does not leak through the seal and be sure to check
the oil level on the dipstick. Then, replenish the engine
oil up to the prescribed level.
6. [Model with the engine filter cover]
Install the engine filter cover.
7. Properly dispose of used oil.
A To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
(1)
(2)
Drain plug
Front tire (LH)
(1) Engine oil filter

Kubota G23-2 Specifications

General

Brand	Kubota
Model	G23-2
Category	Lawn Mower
Language	English