PERIODIC SERVICE74
ENGLISH
BCleaning Transmission Strainer
When changing the transmission fluid, disassemble and
rinse the strainer with nonflammable solvent to completely
clean off fillings.
When reassembling be careful not to damage the parts.
A Since the fine filings in the oil can damage the
precision component parts of the hydraulic system, the
end of the suction line is provided with an oil strainer.
BReplacing Fuel Filter
Change fuel filter every 400 hours. This should be done by
your local KUBOTA Dealer.
EVERY 1500 HOURS
BChecking Fuel Injection Nozzle (Injection
Pressure)
Consult your local KUBOTA Dealer for this service.
EVERY 3000 HOURS
BChecking Injection Pump
Consult your local KUBOTA Dealer for this service.
EVERY 1 YEAR
BReplacing Air Cleaner Element
Change the element once a year.
EVERY 2 YEARS
BFlush Cooling System and Changing
Coolant
To avoid personal injury:
A Do not remove the radiator cap while coolant is
hot. When cool, slowly rotate cap to the first
stop and allow sufficient time for excess
pressure to escape before removing the cap
completely.
1. Stop the engine and let cool down.
2. To drain the coolant, remove the radiator hose and the
radiator cap. The radiator cap must be removed to
completely drain the coolant.
3. After all coolant is drained, install the hose securely.
4. Fill with clean water and cooling system cleaner.
5. Follow directions of the cleaner instruction.
6. After flushing, fill with clean water and anti-freeze until
the coolant level is just below the port.
7. Fill with clean water and anti-freeze up to the upper
line of recovery tank.
8. Install the radiator cap securely.
9. Start and operate the engine for a few minutes.
10.Stop the engine. Check coolant level and add coolant
if necessary.
(1) Strainer
(2) O ring
Coolant capacity
(with recovery tank)
G23-2 3.1 L
G26-2 3.3 L
To Next Page
Need help?
General
