SERVICE PRECAUTIONS
n Make sure to install new gaskets, O-rings,
circlips, cotter pins, etc. when
reassembling.
n When tightening bolts or nuts, begin with
larger-diameter to smaller ones at several
times, and tighten to the specified torque
diagonally.
n Use genuine parts and lubricants.
n When servicing the motorcycle, be sure to
use special tools for removal and
installation.
n After disassembly, clean removed parts.
Lubricate sliding surfaces with engine oil
before reassembly.
n Apply or add designated greases and
lubricants to the specified lubrication
points.
n After reassembly, check all parts for
proper tightening and operation.
n When two persons work together, pay
attention to the mutual working safety.
n Disconnect the battery negative (-) terminal
before operation.
n When using a spanner or other tools, make
sure not to damage the motorcycle surface.
n After operation, check all connecting
points, fasteners, and lines for proper
connection and installation.
n When connecting the battery, the positive
(+) terminal must be connected first.
n After connection, apply grease to the
battery terminals.
n Terminal caps shall be installed securely.
To Next Page
Loading...
Need help?
General
