Inspect the top of the cylinder for warpage.
Service Limit: 0.05mm repair or replace if over
Measure the connecting rod small end I.D.
Service Limit: 15.06mm replace if over
PISTON RING INSTALLATION
Install the piston rings onto the piston.
Apply engine oil to each piston ring.
• Be careful not to damage the
piston and piston rings during
assembly.
• All rings should be installed with
the markings facing up.
• After installing the rings, they
should rotate freely without sticking.
• Stagger the ring end gaps as the
figure shown.
To Next Page
Loading...
Need help?
General
