9-21
User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration
NW User Property (Obtain Network User Property)
Set the required information to obtain the network user property from the LDAP server. The user name and E-mail
address obtained with this setting is shown in the user information, the status confirmation screen, and the header of
E-mail.
1
Display the screen.
1
[
System Menu/Counter
] key > [ā²] [ā¼] key > [
User/Job Account
] > [
OK
] key
2
[ā²] [ā¼] key > [
User Login Set.
] > [
OK
] key
2
Configure the settings.
[ā²] [ā¼] key > [
NW User Property
] > [
OK
] key > [ā²] [ā¼] key > [
Off
] or [
On
] > [
OK
] key
ā¢ To obtain the network user property from the LDAP server, [
Netwk Authentic.
] must be selected for the
authentication method in "Enabling User Login Administration". Select "On" for "LDAP" in "Protocol Detail".
Enabling User Login Administration (page 9-3)
Protocol Detail (page 8-27)
ā¢ Setting to obtain network user information is performed from the operation panel. The details of the information to be
obtained should be set with Command Center RX.
Command Center RX User Guide
If the login user name entry screen appears during operations, enter a login user name
and password, and select [
Login
]. For this, you need to login with administrator
privileges.
The factory default login user name and login password are set as shown below.
Login User Name: 3000
Login Password: 3000
To Next Page
Loading...
Need help?
General
