3-3
Fax transmission > Basic transmission procedure
6
Send Start.
Press the [Start] key.
When scanning finishes, transmission starts.
When originals are placed in the document processor
After originals placed in the document processor are scanned and stored in the memory, the receiving system is
dialed.
When originals are placed on the glass surface
After originals placed on the glass surface are scanned and stored in the memory, the receiving system is dialed.
Using redial
Redial is a function allowing you to dial the last entered number once again.
Use this when the receiving system does not respond when you have tried to send a fax. To send FAX the last entered
number once again. When you want to send the fax to the same receiving system, select [Recall], and you can call the
receiving system you dialed on the destination list.
1
Select [Recall].
2
Press the [Start] key.
Transmission begins.
Checking the Send Status
1
Select the [Status/Job Cancel] key.
2
Display the send job status screen.
Select [Sending Jobs].
The list of accepted time, destination, and status are displayed for each job.
Priority Override Send
A fax job waiting to be sent can be sent by priority override.
• When continuous scan is set, you can continue with scanning of a next original after an original on the glass
surface has been stored in memory. Every time one page is scanned, you perform an operation to allow
continued scanning, and after all the originals have been stored in memory, the receiving system is dialed.
[Continuous Scan] (5-5)
• If there is no response from the other machine when you attempt to send, the machine will automatically
redial (auto redial). You can change the number of auto redial attempts.
Retry Times (8-9)
Recall information is canceled in the following conditions.
• When you turn the power off
• When you send a next fax (new recall information is registered)
• When you log out
To Next Page
Loading...
Need help?
General
Weight and Dimensions
