7: Interfaces
Spider™ and SpiderDuo® KVM-over-IP Device User Guide 73
b. Click Upload to load the image into Spider device’s memory. This floppy drive is
accessible to the remote computer as a letter-name floppy drive (e.g., B:). Information
about the image displays in the Virtual Media Active Image section of the page.
Figure 7-9 Virtual Media Active Image
3. If desired, in the Virtual Media Active Image section:
a. Click Reactivate if the remote machine does not recognize the image.
b. Click Download to save the image file.
c. Click Discard to remove the current image file.
Connecting to a Redirected Drive
If Drive Redirection is enabled, you can connect to the drive. Depending on the combination of the
type of drive and the Force read-only connections setting, different warnings display.
To connect to a redirected drive, perform the following steps.
1. Click the KVM Console button at the top of the Spider device web page or click the console
image that you see when you log in to the Spider device. The Remote Console displays?
2. Click the disk icon in the toolbar. Drive Redirection buttons display at the top left of the
page.
To Next Page
Loading...
Need help?
General
