Lexmark MS810 User Manual

Too many disks installed [58]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra printer hard disks.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Too many flash options installed [58]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra flash memory.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Too many trays attached [58]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra trays.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Unformatted flash detected [53]
Try one or more of the following:
• From the printer control, select Continue to stop the defragmentation and continue printing. For non‑touch‑screen
printer models, press
to confirm.
• Format the flash memory.
Note: If the error message remains, then the flash memory may be defective and need to be replaced.
Unsupported disk
An unsupported disk has been inserted. Remove the unsupported disk, and then install a supported one.
Unsupported option in slot [x] [55]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
Troubleshooting 301

Lexmark MS810 Specifications

General

Print Technology	Monochrome Laser
Print Speed	Up to 55 ppm
Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 300, 000 pages
Processor Speed	800 MHz
Standard Memory	512 MB
Maximum Memory	2560 MB
Connectivity	USB, Ethernet
Duplex Printing	Standard
Media Types Supported	Card Stock, Envelopes, Labels, Plain Paper, Transparencies
Maximum Paper Size	Legal
Operating System Compatibility	Windows, Mac, Linux
Input Capacity	650 pages (Standard)
Maximum Paper Input	4400 pages