EasyManuals Logo

Lexmark MS810 User Manual

Lexmark MS810
364 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #346 background imageLoading...
Page #346 background image
Additional rights
Some states do not allow limitations on how long an implied warranty lasts, or do not allow the exclusion or limitation
of incidental or consequential damages, so the limitations or exclusions contained above may not apply to you.
This limited warranty gives you specific legal rights. You may also have other rights that vary from state to state.
Modular component notice
This product may contain the following modular component(s):
Lexmark Regulatory Type/LEX-M01-005; FCC ID: IYLLEXM01005; Industry Canada IC: 2376A-M01005
Multiple model information
The following information applies to all MS810, MS811, and MS812 models except for the MS812de model.
Federal Communications Commission (FCC) compliance information statement
This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.
The FCC Class B limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult your point of purchase or service representative for additional suggestions.
The manufacturer is not responsible for radio or television interference caused by using other than recommended
cables or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could
void the user's authority to operate this equipment.
Note: To assure compliance with FCC regulations on electromagnetic interference for a Class B computing device,
use a properly shielded and grounded cable such as Lexmark part number 1021231 for parallel attach or 1021294 for
USB attach. Use of a substitute cable not properly shielded and grounded may result in a violation of FCC
regulations.
Any questions regarding this compliance information statement should be directed to:
Director of Lexmark Technology & Services
Lexmark International, Inc.
740 West New Circle Road
Lexington, KY 40550
(859) 232–3000
Notices 346

Table of Contents

Other manuals for Lexmark MS810

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lexmark MS810 and is the answer not in the manual?

Lexmark MS810 Specifications

General IconGeneral
Print TechnologyMonochrome Laser
Print SpeedUp to 55 ppm
Print Resolution1200 x 1200 dpi
Monthly Duty CycleUp to 300, 000 pages
Processor Speed800 MHz
Standard Memory512 MB
Maximum Memory2560 MB
ConnectivityUSB, Ethernet
Duplex PrintingStandard
Media Types SupportedCard Stock, Envelopes, Labels, Plain Paper, Transparencies
Maximum Paper SizeLegal
Operating System CompatibilityWindows, Mac, Linux
Input Capacity650 pages (Standard)
Maximum Paper Input4400 pages

Related product manuals