D9U001MC0-0101_16
31
9 Power Supply Cord (Mains Power Cable)
CAUTION!
Disconnecting bed from the mains does not stop motions of the bed!
► Stop the bed before disconnection bed from the mains.
Attachment plug is means of connecting and disconnecting bed from the mains.
Power supply cable (mains power cable) must be attached with a hook at the head board during transport.
Where the integrity of the external protective conductor in the installation or its arrangement is in doubt
► operate the bed from internal accumulator only.
10 Accumulator
CAUTION!
Material damage due to temperature difference!
► If there is a considerable temperature difference between the bed and the place of operation (after transport/sto-
rage), leave bed unconnected for 24 for the difference to balance itself.
The accumulator supplied with the bed is delivered uncharged. The accumulator serves as a backup during power failures or while
transporting the patient.
For declared lifetime period of leaded accumulators is recommended during storage:
1) To prevent accumulators from deep discharging and to keep accumulators at least partly charged by regular recharging
2) To store accumulators on the places with temperature from 10°C to 40°C
3) To prevent accumulators from being in the sunshine
Accumulator lifetime could be up to 5 years if operated under optimum conditions.
Accumulator capacity can be signicantly reduced if:
► too high ambient temperature
► many accumulator charge/discharge cycles
► recurrence of deep discharge
► bed is often powered only by the accumulator
10.1 Accumulator Operation
► Use only accumulator approved by the manufacturer.
► Check the functionality of accumulators at least once a month in accordance with the user and service manuals and have
the accumulator changed if necessary.
► Use exclusively accumulator approved by the manufacturer.
NOTE The service life of the accumulator depends on the frequency and method of use.
The manufacturer will assume no responsibility for any damage to the bed or the accumulator caused by:
■ non-observance of the manufacturer’s instructions in the instructions for use
■ using accumulator not approved by the manufacturer
NOTE The manufacturer provides a 6-month warranty for the full function of the accumulator.
To charge the accumulator:
► Connect the bed to the mains.
NOTE Some bed adjustment options are not available without a accumulator, for example, height adjustment under a load of
above 200 kg.
To Next Page
Loading...
Need help?
General
