35
Chapter 5: Using the Web-based Utility for Configuration
Security Tab - Authenticated Users
16- or 24-Port 10/100/1000 Gigabit Switch with WebView
Security Tab - Authenticated Users
The Authenticated Users screen shows the user port access lists.
User Name. Use this drop-down list to view the users who were authenticated and are permitted on each port.
Port. This is the port number.
Session Time. This is the number of seconds the user was logged on the port.
Authentication Method. This is the authentication method used during the most recent session. Remote
indicates that the port is forceauthorized. None indicates that no authentication method was used. RADIUS
indicates authentication by a RADIUS server.
MAC Address. Displayed here is the MAC address of the user.
Security Tab - System Password
The System Password screen lets you set a password for access to the Switch.
User Name. The User Name is automatically displayed.
Password. Enter the system password for this user.
Confirm Password. Enter the same system password in this field.
Click the Submit button to save your changes.
SNTP Tab - Global Settings
The Global Settings screen lets you set the Simple Network Time Protocol (SNTP) settings. SNTP makes possible
accurate time synchronization by a network SNTP server for network devices. Using SNTP, the Switch is
synchronized with the rest of the network and set with the correct time.
Poll Interval. Enter the interval (in seconds) at which the SNTP server is polled for unicast information.
Receive Broadcast Servers Updates. If enabled, the Switch listens to the SNTP servers for broadcast server
time information on selected interfaces.
Receive Anycast Servers Updates. If enabled, the Switch polls the SNTP server for anycast server time
information.
Figure 5-33: Security - Authenticated Users
Figure 5-34: Security - System Password
Figure 5-35: SNTP - Global Settings
To Next Page
Loading...
Need help?
General
