49
Chapter 5: Using the Web-based Utility for Configuration
Maintenance Tab - Telnet
16- or 24-Port 10/100/1000 Gigabit Switch with WebView
Event Log. Select the types of logs that you want to save to the Event Log.
Message Log. Select the types of logs that you want to save to the Message Log.
Click the Submit button to save your changes.
Maintenance Tab - Telnet
The Telnet screen lets you connect to the Switch through telnet, a terminal emulation TCP/IP protocol.
Connect Via Telnet. If you use a telnet connection, click Connect Via Telnet. The HyperTerminal screen will
automatically appear.
Maintenance Tab - Reset
The Reset screen lets you reset the Switch from a remote location.
Reset the Device. If you want to reset the Switch, click Reset the Device. You will be asked to confirm the reset.
Click the OK button. After the Switch is reset, you will be prompted for a user name and password before you can
access the Web-based Utility.
Maintenance Tab - File Download
The File Download screen lets you download firmware or a configuration file to the Switch. You cannot download
both at the same time.
Firmware Download. If you want to download firmware, click this radio button. If this is selected, then the
Configuration Download fields will not be available.
Configuration Download. If you want to download a configuration file, click this radio button. If this is selected,
then the Firmware Download fields will not be available.
Figure 5-57: Maintenance - Telnet
Figure 5-58: Maintenance - Reset
NOTE: Before you reset the Switch, you should update your startup configuration file so you will not
lose your current configuration settings.
NOTE: You can perform only one type of download at a time.
Figure 5-59: Maintenance - File Download
To Next Page
Loading...
Need help?
General
