GROVE 11-45
CD3340B/YB4411 STRUCTURAL
11
Published 04/07/2015 Control # 569-00
4. Note that the roll pin is slightly recessed in the carrier
when properly installed. With a center punch
(Figure 11-105); stake the carrier next to the pin hole as
shown. This will distort the hole so the pin will not back
out. Repeat these steps for each of the three planet
gears.
Primary Planet Carrier
1. To service the primary planet carrier, the steps are the
same as for the output carrier except there is only one
bearing for each gear and no bearing spacer.
Motor Support-Brake
Cylinder Service
IMPORTANT!
Some of the illustrations show spined brake discs. This
brake uses a lobed steel brake separator and motor
support as shown in Figure 11-106.
Disassembly
1. Remove spacers, friction brake discs and steel brake
discs (Figure 11-107).
2. Remove the piston backup ring and pressure plate
(Figure 11-108).
Reference Only
To Next Page
Loading...
Need help?
General
