Rigging work
12.6 Slewing range – only with the Standard slewing range type
Operating manual 3 302 709 en 12 - 31
GMK5150L
12.01.2018
12.6 Slewing range – only with the Standard slewing range
type
The information in this section applies only to the Standard slewing range
type. If you wish to operate the truck crane using the
MAXbase slewing
range type;
à p. 12 - 33.
All permissible outrigger spans are symmetrical. All outrigger beams are
extended and all outrigger beams are extended to the same outrigger span;
à Enabled outrigger spans, p. 12 - 32.
12.6.1 Representation in the lifting capacity tables
The outrigger span is always specified in this
form in the
Lifting capacity table.
Outrigger length xxxx – outrigger width yyyyy
– Outrigger length
The outrigger length (
I) has a fixed value
of 8.030 m (26.3 ft) and never changes for
a fully supported truck crane.
– Outrigger width
The outrigger span relates to the overall
width (
II). There are five outrigger
spans (1) to (5).
To Next Page
Loading...
Need help?
General
