Rigging work
12.9 Rigging/unrigging the counterweight
Operating manual 3 302 709 en 12 - 71
GMK5150L
12.01.2018
12.9 Rigging/unrigging the counterweight
For driving, parts of the counterweight must be set down on the counter-
weight platform, installed on the turntable or removed, depending on the
driving mode;
à Driving modes, p. 6 - 1
12.9.1 Information on rigging
Rigging the counterweight is a challenging task. Only experienced person-
nel who are familiar with the valid accident prevention regulations are
authorised to sling counterweight sections and instruct the crane operator.
When the engine is running for crane operation, the rigging personnel may
only climb on the truck crane when the slewing gear is switched off and the
slewing gear brake is applied.
The crane operator and rigging personnel must maintain visual contact
during the rigging process.
The rigging process for a single counterweight section is described.
Proceed in the same manner when rigging other counterweight sections
or blocks.
When rigging As the crane operator
• Lift the counterweight section onto the counterweight platform as
described in the section
Assembling counterweight combination.
• Now inform the rigging personnel that they can climb on the truck crane.
As the rigging personnel
• Do not climb on the truck crane until permitted by the crane operator.
• Position the counterweight if necessary.
s
To Next Page
Loading...
Need help?
General
