Manitowoc Grove RT765E-2 User Manual

SET-UP AND INSTALLATION RT765E-2 OPERATOR MANUAL
4-18 Published 4-09-2021, Control # 364-11
18. Install the attachment pin into the upper anchor and
attachment fitting on the left side of the boom nose.
Install retainer clip in attachment pin.
NOTE: If the boom extension alignment device does not
properly align the anchor and attachment fittings to
allow installation of the last attachment pin, refer to
the Service Manual and adjust the boom extension
alignment device.
19. Fully retract the boom until the bottom extension anchor
fitting is against the boom extension alignment device
and install the attachment pin in the lower anchor and
attachment fittings on the left side of the boom nose.
Install the retainer clip in the attachment pin.
20. Lower the boom and remove the rope from the tip of the
extension base section.
21. Remove the hitch pin and clip pin securing the boom
extension alignment device in the working position.
Push the push bar assembly back to the stowed position
and secure it in place with the hitch pin and clip pin.
22. Connect RCL cables:
a. Remove RCL cable end connector (1) Figure 4-13
from extension and route through boom extension.
b. Remove dummy plug (1) Figure 4-14 from junction
box on boom nose.
c. Install cable end connector (1) Figure 4-15 from
boom extension where dummy plug was removed.
23. Erect the boom extension fly section as follows:
a. Attach a length of rope to the tip of the extension fly
section to aid in swinging the fly into place ahead of
the base section. Ensure that the right base to fly
extension attachment pin is in place.
b. Position the boom to horizontal.
c. At the fly section sheave end (see detail E), push in
on the spring loaded latch hook to release the latch
allowing fly to separate from the base.
d. Slightly raise and/or lower the boom to help control
the extension fly. Using the rope attached to the tip
of the fly section, swing the fly into place ahead of
the extension base, engaging the anchor fittings
with the attachment fittings on the left side of the
base section.
DANGER
Do not modify the attach points to permit the installation of
the attach pins.
DANGER
Do not attempt to erect the fly section unless it was
attached to the boom extension base section during the
initial erection procedure.
6642-19
FIGURE 4-13
1
DANGER
When erecting the extension fly section, ensure that all
personnel and equipment are kept clear of the swing path.
6642-20
FIGURE 4-14
1
6642-21
FIGURE 4-15
1

Manitowoc Grove RT765E-2 Specifications

General

Brand	Manitowoc
Model	Grove RT765E-2
Category	Construction Equipment
Language	English