Instrument cluster
1 Vehicles without steering wheel
buttons
2 Vehicles with steering wheel but-
tons
Instrument cluster
3 Adjustment buttons
, Button
. Button
5 Menu button
Reset button 0
> Check the engine oil level
(
e page 254)
The display in the instrument cluster is ac-
tivated when you:
I
open the driver’s door
I
turn the key to position 2 in the ignition
lock
I
press the 0 reset button
I
switch on the lights
The display switches off automatically
after approximately 30 seconds if:
I
the vehicle lighting is not switched on
I
the key is in position 0 in the ignition
lock
G
Risk of accident
No messages can be displayed if the instru-
ment cluster and/or the display fails.
You will not then be able to see information
about the vehicle status, such as speed, out-
side temperature, warning and indicator
lamps, malfunction and warning messages
or the failure of systems. Handling charac-
teristics may be affected.
Contact a qualified specialist workshop im-
mediately which has the necessary special-
ist knowledge and tools to carry out the
work required. Mercedes-Benz recommends
that you use a Mercedes-Benz Service
Centre for this purpose. In particular, all
work relevant to safety or on safety-related
systems must be carried out at a qualified
specialist workshop.
G
Risk of accident
Only use adjustment buttons ,, ., 5, 0
or
> when the traffic conditions permit.
You would otherwise be too distracted and
could cause an accident.
Do not reach through the steering wheel to
operate the adjustment button. The move-
ment of the steering wheel would be signifi-
cantly impeded. Your attention would also
be diverted from the road and traffic condi-
tions. This could cause you to lose control
of the vehicle and lead to an accident.
Controls
Instrument cluster
100
3
Nur fuer internen Gebrauch
To Next Page
Loading...
Need help?
General
