Bulb arrangement
3 Brake lamp/tail lamp
4 Turn signal lamp
5 Reversing light
6 Rear foglamp (driver’s side only)
E To change the bulb: press the bulb to
the rear.
E Turn it anti-clockwise and remove it
from the bulb holder.
E Press the new bulb into the bulb holder
and screw it in clockwise.
E To fit the rear light cluster: engage
the bulb holder in the rear lamp clus-
ter.
E Press the electrical connector into the
bulb holder.
E Align the rear light cluster from the
side, with the locating lugs in the fas-
tener holes.
E Turn the rear light cluster inwards.
E Align the three securing bolts 1
(
e page 327) and tighten.
Changing the additional bulbs
Licence plate lamp
1 Bulb holder
2 Licence plate bulb
E Switch the lights off.
E Press the bulb to the rear.
E Turn the lamp with a suitable tool, e.g.
a screwdriver, anti-clockwise against
the spring force and remove it.
E Remove the cover.
E Pull licence plate bulb 2 out of bulb
holder
1.
E Push new licence plate bulb 2 into
bulb holder
1.
E Place the cover on the lamp.
E Replace the lamp and press it inwards
until it engages.
Additional turn signal lamp
1 Turn signal lamp housing
E Slide turn signal lamp housing 1 for-
wards and swing it out.
Practical advice
Electrical system
328
5
Nur fuer internen Gebrauch
To Next Page
Loading...
Need help?
General
