Mercedes-Benz Vito User Manual

E Turn the light switch to U .
The side lamps are switched on/off au-
tomatically when the key is in position
1 in the ignition lock.
Parking lamps, dipped-beam head-
lamps and licence plate illumination
are switched on/off automatically in
accordance with ambient light condi-
tions when the engine is running.
Only use manual headlamp mode when
you are driving in countries where driving
with dipped-beam headlamps is required
by law.
E In this case, turn the light switch to
B.
Front foglamps/rear foglamp
E Turn light switch 1 to B or C.
E Rear foglamp: pull light switch 1 out
to the first stop.
The
f green indicator lamp next to
the light switch lights up.
E Rear foglamp: pull light switch 1 out
to the second stop.
The
e yellow indicator lamp next to
the light switch lights up.
Headlamp range control
The headlamp range control is used to
adapt the downward angle of the head-
lamp beams in accordance with the load
on your vehicle. The downward angle of
the headlamp beams changes depending
on whether seats are occupied or the load
compartment is laden or unladen. This
could impair visibility and dazzle oncoming
traffic.
You can only adjust the headlamp range
while the engine is running.
The thumbwheel for the headlamp range
control is located to the right of the light
switch.
1 Thumbwheel for headlamp range con-
trol
0 Front seats occupied
1 Front and rear seats occupied
2 Front and rear seats occupied and
load compartment loaded up to
maximum rear axle load
3 Driver’s seat occupied and load
compartment loaded up to maxi-
mum rear axle load
E Turn thumbwheel 1 to the setting re-
quired.
i Vehicles with electronic level control are
equipped with an automatic headlamp range
control. On these vehicles, the headlamp range
cannot be controlled manually.
Controls
Lighting
139
3
Nur fuer internen Gebrauch

Mercedes-Benz Vito Specifications

General

Brand	Mercedes-Benz
Model	Vito
Category	Automobile
Language	English