Level control
The vehicle’s rear axle is equipped with
pneumatic suspension and electronic level
control (ENR). ENR maintains the vehicle’s
ride height regardless of the vehicle load.
Electronic level control (ENR):
I
improves road safety
I
makes it easier to load the vehicle
I
improves comfort
G
Risk of accident
If the vehicle level is too high or too low
while you are driving, the chassis could be
damaged, and unstable handling character-
istics cannot be ruled out. Drive on carefully
until the
ú indicator lamp in the instru-
ment cluster goes out. You could otherwise
endanger yourself and others.
Vehicle level
You can set the following ENR modes:
I
Standard mode: automatic control to
maintain standard ride height both dur-
ing a journey and when stationary.
I
Manual mode: you can raise or lower
the vehicle level.
I
Passive mode: level control is inactive.
This is useful, e.g. for work in the work-
shop, when changing a tyre, or in the
event of malfunctions in the level con-
trol system.
1 To switch control on/off (ENR OFF but-
ton)
2 To raise/lower
3 Indicator lamp
Manual mode
E To open the tailgate/door
E Press switch 2 on the right-hand side
panel in the rear in the desired direc-
tion and hold for 2 seconds.
ENR is in manual mode. You can raise
or lower the vehicle.
With the ignition switched on:
I
the ú indicator lamp in the in-
strument cluster flashes
I
indicator lamp 3 in ENR OFF
switch
1 flashes
E To lower the vehicle: press lower sec-
tion of switch
2 until the vehicle has
reached the desired position.
E To raise the vehicle: press upper sec-
tion of switch
2 until the vehicle has
reached the desired position.
E To raise the vehicle automatically to
the normal level: briefly press the
upper section of button
2 if the ve-
hicle is below the normal level.
ENR automatically raises the vehicle to
the normal level.
If you want to halt the vehicle level at a
certain position:
Controls
Level control
198
3
Nur fuer internen Gebrauch
To Next Page
Need help?
General
