I
the sunroof has been closed manually
using the T-shaped emergency key
(
e page 339)
I
has not opened smoothly
I
a malfunction
I
an interruption in the voltage supply as
a result of a disconnected or flat bat-
tery
E Turn the key to position 2 in the igni-
tion lock.
E Press the sliding/tilting sunroof switch
to
2.
E Once the sliding/tilting sunroof is
closed keep the switch pressed for ap-
proximately three seconds.
The sliding/tilting sunroof is reset.
Opening and closing the sliding sun-
roof using the control panel in the rear
compartment
i The sliding sunroof in the rear compart-
ment consists of two separate roof sections.
The rear roof can be operated from the rear
compartment.
The switch for the sliding sunroof is lo-
cated on the roof cross member in the
rear compartment.
1 To open
2 To close
E Turn the key to position 2 in the igni-
tion lock.
E Press the sliding sunroof switch in the
desired direction as far as the first
pressure point.
E Release the sliding sunroof switch
when the desired position has been
reached.
i If you press the sliding sunroof
switch beyond the pressure point and then re-
lease it, the sliding sunroof automatically opens
or closes fully.
To stop the sunroof, press the sliding sunroof
switch again in any direction.
! Do not transport objects which protrude
from the sliding sunroof. You could otherwise
damage the sliding sunroof.
Opening and closing the roller sunblind
1 Release button
E To open: press the dimpled surface of
release button
1 to open the roller
sunblind.
! When you open the roller sunblind, you
must guide it as far as it will go to the rear, oth-
erwise it could be pulled back by the tension of
the spring.
This could result in damage to the roller sun-
blind. Only close the roller sunblind when the
sliding/tilting sunroof is closed.
Controls
Opening and closing
78
3
Nur fuer internen Gebrauch