MG Hector User Manual

107106
instrument panel lamp and backlight of all the
panels illuminate.
= The low beam lamp and all lamps
mentioned above illuminate under the
precondition that the ignition switch is turned
to ON position.
LIGHTING
Outside Lighting
Lighting Switches
To switch ON or OFF the headlamp, tail lamp
and parking lamp, please turn the end of the
combination switch control lever.
The lighting switch has 3 positions and they
represent different lighting functions:
OFF= All the lamps are turned off.
AUTO= Automatic Light Control turns the
lights on whenever the sensor, in the
instrument panel, senses dark conditions. The
system will activate the lights when the car is
driven in a enclosure, such as a parking garage.
Heavy overcast conditions can cause the lights
to switch on.
= The position lamp, license plate lamp,
The headlamp high beam indicator illuminates
when the headlamp high beam is turned on. To
switch from headlamp high beam to low beam,
pull the control lever towards the opposite
direction until it returns to the normal
position.
Automatic Headlamp ON / OFF
When the ignition switch is in ON position,
turn the combination switch lever to AUTO
Position. This activates automatic headlamp
ON / OFF function.
The system's light sensor recognizes the
environment's light and dark condition.
Headlamp Flashing
To activate headlamp high beam flashing,
please pull the combination switch control
lever toward yourself and then release it. The
control lever will return to the normal
position as you release it.
Before you release the control lever, the
headlamp high beam keeps illuminated.
High Beam
To turn on headlamp high beam:
• Ensure that the ignition switch is in ON
position;
• The headlamp is in a low beam state;
• As is shown in the figure, push the
combination switch control lever towards
the instrument panel.
While approaching incoming vehicle or
the vehicle ahead, please use low beam.
This is because headlamp high beam can
make other driver feel temporarily blind
and cause collision as a result.
Warnings
The sensor is installed on the front windshield
Light and rain sensors are used to sense light
and rain. The control module provides sensing
signals for bad / good lighting & amount of
water vapor / rainfall on the surface of the
glass.
The automatic control (AUTO) function of
the wiper / headlamp acts accordingly.
Stains or snow and ice can affect the sensor's
performance. Please clean up the glass on
time.
LIGHTING
Hazard Flasher
Press to turn on/off the hazard flasher.
Turn and Lane Change Signal Lamp
To turn on the Turn And Lane Change Signal
Lamp, the ignition switch must be in ON
position.
Control lever upward = right turn signal lamp
Control lever downward = left turn signal
lamp
After cornering, the turn signal interrupts
automatically and the control lever returns to
the normal position.
To change the lane, you can pull the control
lever to halfway position (not reaching the
turn signal lamp position) and keep pulling it.
After lane change, release the control lever
and it will return to the normal position
automatically.
Automatic Wiping
Please turn on the lights manually in a
dense fog environment. The lighting
system may not automatically turn ON
because of dense fog. Automatic lighting
control is just an auxiliary function. The
driver should use lights as per the
requirement of environment.
Note

MG Hector Specifications

General

Brand	MG
Model	Hector
Category	Automobile
Language	English