171170
Auto Transmission Clutch Fluid Adding *
The vehicle equipped with auto transmission
has an independent clutch fluid reservoir.
1. Thoroughly wipe off the dirt around the
reservoir filler cap.
2. Open the filler cap.
3. Add the clutch fluid recommended by MG
Motor to reach the MAX (maximum)
mark. Be careful not to spill the fluid
outside the reservoir. In case of spilling on
the paint surface, wash the area with cold
water immediately.
4. Re-install the reservoir filler cap.
The level inspection and adding of clutch fluid
require skills, and the fluid replacement
requires specialized skills and equipment. It is
recommended to go to a service center for
vehicle maintenance on time. For any help,
please contact the service center.
Before opening the filler cap, clean the
area around the brake / clutch fluid
reservoir filler cap.
Contamination of the brake/clutch fluid
s y s t e m w i l l a f f e c t t h e s y s t e m
performance, resulting in costly repairs.
Note
The brake / clutch fluid is irritating to the
skin and eyes.
Keep the skin or eyes from contact with
the brake/clutch fluid. In case of contact,
wash the part in contact with the
brake/clutch fluid with soap water or
hand sanitizer thoroughly.
Caution
It is prohibited to dispose of the old
brake/clutch fluid as household garbage.
It shall make use of local legal waste
management organization.
The old brake/clutch fluid and containers
are dangerous and may be harmful to
human health and the environment.
Caution
The brake/clutch fluid spilling over the
engine may cause a fire.
An overfull fluid reservoir is not allowed.
Engine fire may cause personal injury and
damage the vehicle and other properties.
Caution
VEHICLE SERVICE & MAINTENANCE
Transmission Fluid
This work requires professional skills and
equipment. To avoid personal injury or vehicle
damage, it is suggested to go to the MG
Authorised Service Center for help.
Transmission Fluid Leakage Check
Windshield Washer Solvent
Before driving, be sure that the fluid reservoir
contains sufficient specified washer solvent.
In cold weather, the windshield washer
solvent container cannot be overfilled.
Washer solvent will swell under low
temperature due to freezing. An overfull
container has no enough space for expansion,
thus resulting in damages.
Please go to the MG Authorised Service
Center for filling of the correct washer
solvent.
Do not fill water or radiator antifreezing
agent into the windshield washer solvent
container. The water will lead the
solution to freeze, and the frozen
solution will damage the windshield
w a s h i n g s y s t e m . T h e r a d i a t o r
antifreezing agent will damage the
windshield washing system and vehicle
paint.
Note
Add windshield washer solvent:
It is suggested to use the ready-to-use
special washer solvent. If concentrated
washer solvent is used, please add water
t o d i l u t e i t a c c o r d i n g t o t h e
manufacturer’s instructions.
Do not use tap water. Minerals or
impurities contained in tap water may
block lines of the windshield washer.
If the temperature is likely to fall below
freezing point, use windshield washer
s o l v e n t w i t h g o o d a n t i f r e e z i n g
performance.
Note
VEHICLE SERVICE & MAINTENANCE
To Next Page
Need help?
General
