195194
There is a hole cover on the left side of the
rear bumper of the vehicle. Open it and the
fixing hole for hook installation can be seen.
Take out the towing hook and install it into the
fixing hole. Rotate the towing hook clockwise
to tighten it completely and insert a socket
wrench into the hook hole to assist tightening.
Be sure that the towing hook is installed firmly
before towing the vehicle.
Do not tow vehicles that are heavier than this
vehicle; otherwise, it may damage the vehicle
or cause accidents.
Rear Towing Hook
The vehicle may be damaged when it is
towed by ropes. To reduce damage:
Ÿ The towing hook must be used when
other traction devices are not available.
Ÿ The vehicle shall be towed from the
front only.
Ÿ Keep the traction rope out of contact
with the bumper.
Ÿ Make sure that both ends of the
traction rope are firmly secured on the
towing hook. Pull the traction rope for
inspection.
Ÿ Drive the vehicle at a low speed and
avoid sharp turning.
Note
The vehicle may be out of control when it
is towed by ropes.
To reduce damage:
Ÿ The towing distance shall not be too
long, and the vehicle should be towed
at a low speed.
Ÿ Do not tow the vehicle if the wheel,
transmission, axle, steering or brake
damage is damaged.
Ÿ Do not remove the key from the
ignition switch; otherwise, the steering
will be locked so that the vehicle
cannot turn.
Note
The towing speed shall not exceed 30
Km/h, and the towing distance shall not
exceed 40 Km. When long-distance
towing is required, it is suggested to
contact the MG Authorised Service
Center or a professional towing service
company for help.
Caution
CVT models are not allowed to be towed
and must be transported by platform
trailer otherwise the transmission will be
damaged.
Caution
VEHICLE SERVICE & MAINTENANCE
When the vehicle is caught in snow, puddle or
other unstable ground, please follow the
procedures below to get the vehicle out of trap.
1. Turn the steering wheel to the ultimate left
and then turn it to the ultimate right. This
will create a vacant area around the front
wheels.
2. Engage the reverse gear and drive gear
back and forth.
3. Reduce wheel idling as far as possible.
4. Release the accelerator pedal when
shifting gear.
5. After engaging the gear, depress the
accelerator pedal gently.
If it fails to get the vehicle out of trap, it is
necessary to tow the vehicle.
Getting Vehicle out of Trap
When the vehicle is caught in snow,
puddle or sandy soil, you need to get the
vehicle out of the trap as soon as possible.
F i r s t , c h e c k w h e t h e r t h e r e a r e
obstructions or people around the
vehicle.
During operation, the vehicle may
suddenly move forward or backward,
hitting the person or object next to it.
Caution
In order to avoid damage to the
transmission and other parts, the
following precautions must be observed
when getting the vehicle out of the trap.
Ÿ Do not depress the accelerator pedal
during gear shifting or when the
transmission is not in a proper gear
position.
Ÿ High engine speed is not allowed, and
wheel idling shall be avoided.
Ÿ If it fails to get the vehicle out of trap
after several efforts, consider other
methods, such as traction.
Note
The manufacturer's suggestions must be
observed when using cleaning agent or other
chemical products inside or outside the
vehicle.
Do not use dangerous cleaning agent when
cleaning the interior and exterior of the
vehicle. For example:
Ÿ Acetone
Ÿ Paint diluent
Ÿ Porcelain glaze reducing agent
Ÿ Nail polish remover
When cleaning the interior and exterior of the
vehicle, the following cleaning agents are
prohibited unless special instructions for
cleaning stains are included in the fabric
cleaning tips:
Ÿ Laundry soap
Ÿ Bleaching powder
Ÿ Reducing agent
Vehicle Maintenance
Cleaning Agent
So me c l ea ni ng a ge nt s ar e to xi c,
corrosive or flammable. Improper use is
very dangerous and may easily cause
personal injury or vehicle damage.
Caution
VEHICLE SERVICE & MAINTENANCE
To Next Page
Loading...
Need help?
General
