179178
Windshield Wiper
Foreign objects on the windshield and blade
will reduce the effectiveness of the wiper. If
the blade does not work properly, wipe the
windshield and the blade with special or
neutral washer solvent. Flush with water
thoroughly. If necessary, repeat the above
operation. Do not wipe the windshield with
corrosive substances or materials that cannot
be removed from the glass (e.g. silicone).
The strips have a layer of graphite on the
surface for lubrication and protection. It
should be protected from excessive wiping
and undue polishing.
Do not start the wiper when the windshield
surface is dry. Park the vehicle in a cool place
as far as possible to prevent exposure to high-
temperature, which will accelerate the aging
and deformation of strips.
Remove foreign matters such as bird
droppings, dust and leaves from the windshield
surface before starting the wiper; otherwise,
the service life of strips will be reduced.
As shown in the figure, firstly press the release
switch of the wiper blade in the direction of
arrow 1. Then hold the joint part between the
wiper blade and the wiper arm with the other
hand. Pull the wiper blade down slightly in the
direction of arrow 2 to separate the wiper
blade from the wiper arm.
During installation, insert and clamp the new
wiper blade into the U-slot of the wiper arm.
During the rear wiper blade removal, pull out
the wiper blade from the installation point on
wiper arm. For installation, align the blade with
the installation point and press it into the
point.
VEHICLE SERVICE & MAINTENANCE
Wiper Blade Removal and Installation
Fold the wiper arm on the windshield for
operation.
Air Filter
Drive Belt
Brake Pedal
Brake Pedal Travel Check
Brake pedal travel:
To avoid affecting the pedal travel, do not lay a
thick carpet in the brake pedal area.
The reasonable range of brake pedal free
travel is 0~30 mm.
If the brake pedal fails to return or the brake
pedal travel becomes longer, please go to the
MG Authorised Service Center for inspection.
This may indicate faults of the brake system.
For normal operation of engine and air
compressor, the drive belt should be adjusted
to a good state. In case of damage, break or
wear, please replace the drive belt.
If the key is not pulled out, the engine
may be start unintentionally during
check. Do not leave the key in the ignition
switch when checking the drive belt.
Sudden running parts may cause serious
personal injury when the engine is in
operation.
Caution
Check and replace the air filter element
regularly according to the maintenance
instructions in the Manual.
Air Filter Cleaning
If the air filter element is too dirty, clean it
according to the following procedures:
1. Shake the air filter element to remove
floating dust.
2. Clean the interior of air filter housing.
3. Cover the filter housing with a wet cloth
when cleaning the filter element.
4. Clean the filter element with compressed
air in the opposite direction of the engine
intake.
Clean air is necessary for the normal
operation of engine.
It is prohibited to drive the vehicle
without the air filter element being
installed. Otherwise, the engine will be
damaged.
Note
VEHICLE SERVICE & MAINTENANCE
To Next Page
Loading...
Need help?
General
