MG Hector User Manual

147146
7. The rate of rotation of the steering wheel
is greater than a certain value.
8. Vehicle speed signal invalid.
9. The rear / front windshield defrosting
function is enabled.
10. The vehicle is on the slope.
11. The ambient pressure is low.
12. ESC works.
When driving through water, please
make sure to disable the start-stop
function.
Caution
Situations of Auto Engine Start
After the engine automatically stops, when the
vehicle is in any one of the following states (AC
should be in switched off condition), the
engine will automatically start:
1. 48V battery voltage is low.
2. The stop time is more than 300s.
3. Unbuckle the driver side seat belt.
4. Open the driver side door.
After the engine automatically stops, if the
engine hood is open, the engine will not
automatically start. The engine must be
started manually.
After automatic stop, although the
engine already flames out, the vehicle is
still in operation. The engine may start at
any time. In case of the following
behaviors, firstly turn off the vehicle
power or pull out the key:
1. The driver leaves the vehicle.
2. The body extends to the engine
compartment.
3. The vehicle is refueled.
Dangers
DRIVING AND CONTROLS
The start-stop timing displays the accumulated
time of the auto engine stop after the ignition
switch is switched on.
The start-stop timing function starts to display
only when the start-stop working indicator
turns on. The maximum display is 99:59:59. It
will restart timing if the value exceeds the
maximum.
Start-Stop Timing
Display the 48V battery capacity.
The 48V power battery is located below the
front passenger seat.
Battery Capacity
Energy Flow Display
No-energy Flow Mode
Represent that there is no energy flowing
because the engine flames out.
DRIVING AND CONTROLS

MG Hector Specifications

General

Brand	MG
Model	Hector
Category	Automobile
Language	English