Miele H 7162 BP User Manual

Cleaning and care
57
 Remove all cleaning agent residues
thoroughly with clean water.
 Dry all surfaces with a soft cloth.
Stubborn soiling on the
FlexiClip runners
Cleaning FlexiClip telescopic runners
in a dishwasher would remove the
special grease which is essential for
their smooth functioning.
Never attempt to clean FlexiClip
telescopic runners in a dishwasher.
For stubborn surface soiling or if the
bearings become sticky with spilled fruit
juices proceed as follows:
 Soak the FlexiClip runners for approx.
10minutes in a solution of hot water
and washing-up liquid.
If necessary use the back of a
washing-up sponge to remove the
soiling. The bearings can be carefully
cleaned with a soft brush.
Cleaning may cause some
discolouration or fading in places,
however this will not affect the
functioning of the runners in any way.
Pyrolytic cleaning of the oven
compartment
Instead of cleaning the oven
compartment manually you can run the
Pyrolytic function.
During pyrolytic cleaning the oven
compartment reaches temperatures in
excess of 400°C. Any residual soiling is
burnt off and turned to ash by the high
temperatures.
There are 3pyrolytic settings available,
each with a different duration:
- Level1 for light soiling
- Level2 for heavier soiling
- Level3 for very heavy soiling
The oven door is automatically locked
when the pyrolytic cleaning process is
started. It cannot be opened until after
the programme has finished.
The timer can be used to delay the start
time of the pyrolytic cleaning
programme, for instance to make use of
cheaper electricity tariffs.
At the end of the pyrolytic cleaning
programme any residues such as ash
from the pyrolytic process, which may
be formed depending on the oven
compartment’s degree of soiling, can be
easily wiped away.

Miele H 7162 BP Specifications

General

Appliance category	Oven
Model	H 7162 BP
Type	Built-in oven
Oven capacity	76 l
Energy efficiency class	A+
Control type	Electronic
Self-cleaning	Yes
Dimensions (H x W x D)	595 mm x 595 mm x 570 mm
Cleaning system	Pyrolytic
Temperature range	30 °C - 300 °C
Operating modes	Conventional heat, Grill
Cleaning	Pyrolytic cleaning