5-28 Switches and controls
• Rotating the grip at the end of the lever activates
the windshield wipers in one of the following
three modes:
INT: Wipers operate intermittently at 3 to 5 sec-
ond intervals.
LO: Wipers operate at a slow speed.
HI: Wipers operate at a rapid speed.
• If the wipers chatter on the windshield or wipe
the windshield unevenly, replace the wiper
blades. P. 12-78
• To activate the windshield washer, push the
button at the end of the lever; the washer fluid
will be sprayed and the wiper will operate one or
two strokes automatically.
• Refill the washer fluid reservoir if the fluid level
is low. P. 12-79
• If there is washer fluid in the reservoir but none
is sprayed when you operate the washer, the
nozzles may be blocked. Clean the nozzles
using a piece of thin wire. If fluid is still not
sprayed when you operate the washer, have the
vehicle inspected by an authorized dealer.
This switch operates the lighting inside the van
body. With the starter switch in the “ON” position,
operate the van body dome light switch to turn the
van body interior lighting on or off. An indicator lamp
comes on in the switch when it is in the ON position.
CAUTION
Leaving the van body interior lighting on for an
extended period without the engine running can
drain the battery.
Van body dome light switch
Z17640
Z17280
FKFM.book Page 28 Wednesday, January 28, 2009 9:21 AM
To Next Page
Loading...
Need help?
General
