5-34 Switches and controls
7 To deactivate the cruise control
Press the OFF side of the main switch.
CAUTION
• Consult an authorized dealer if you wish to
install a radio transmitter/receiver equip-
ment. Proper operation of the cruise control
cannot be ensured if this equipment is
installed in an inappropriate location or is
incorrectly adjusted.
• If the (red) or warning lamp illumi-
nates, turn off the cruise control main switch
and have the vehicle inspected by an autho-
rized dealer.
• When there is a problem with the engine
control system, the cruise control cannot be
used.
<Rear air suspension vehicles>
It is possible to lower the cargo bed while the vehi-
cle is stationary. This function can be used with the
starter switch in “ON” or “ACC” position.
NOTE:
• The height control switch should be turned off
when adjustment of the cargo bed height is not
being performed.
• Compressed air will be required to move the
cargo bed back to driving height. It is important,
therefore, that the engine be started up.
• Extended periods of use while the engine is not
running can be the cause of flat batteries.
1 Lowering the cargo bed
1. Set the starter switch in “ON” or “ACC” position.
2. Apply the parking brake securely. In a manual
transmission vehicle, set the gearshift lever in
neutral. In an automatic transmission vehicle,
set the range selector lever in “P” or “N” range.
Air suspension height control
Z17284
Z15220
FKFM.book Page 34 Wednesday, January 28, 2009 9:21 AM
To Next Page
Loading...
Need help?
General
