128
STEP 4: Press the Regist key. The following message
appears for 3 seconds.
To Replace the Existing Data Assigned to
a the One-Touch Speed Calling Key with
New Data Using SPD Set Key
STEP 1: Press the SPD Set key.
STEP 2: Press the desired One-Touch Speed Call-
ing key.
STEP 3: The phone number already registered is dis-
played. Press key or the Edit soft key.
STEP 4: Enter the desired phone number (Up to 32
digits can be registered).
STEP 5: Press the Regist key. The following message
appears for 3 seconds.
Note:
During the registration operation, pressing any
other key (Exit, SPD Set, or Cnl) cancels the set-
ting. In that case, the terminal operates in accor-
dance with the pressed key.
Note:
When you receive an incoming call on the
accommodated line while programming the One-
Touch Speed Calling key, you can continue with
the programming without answering the call.
However, if you answer the call, the conversation
will be started and the registration operation will
be canceled.
Note:
A new entry overwrites the previously saved
phone number (the existing number temporarily
displays when you try to set a new number).
Entry is added!
1:25 PM MON 11 MAY 2015
SPD Set Mic NoDist
1:25 PM MON 11 MAY 2015
SPD Set Mic NoDist
Push Speed Calling Key
1:25 PM MON 11 MAY 2015
SPD Set Mic NoDist
08211XX
ReRegi Edit Delete
Entry is added!
1:25 PM MON 11 MAY 2015
SPD Set Mic NoDist
To Next Page
Loading...
Need help?
General