127
To Operate From Speed Calling – System
Key
STEP 1: Press the “Speed Calling – System” key.
STEP 2: If the terminal does not have the “Speed Call-
ing – System” key, dial the “Speed Calling –
System” access code, then the abbreviated
call code.
To Operate From Directory Key
(Only DT410 Series equipped with a Directory key.)
STEP 1: Press key.
STEP 2: Dial the abbreviated call code (maximum of 4
digits).
ONE-TOUCH SPEED CALLING
SETTING USING SPD SET KEY
You can add, edit, or delete a One-Touch Speed
Calling key using a programmable Line/Feature key or
a SPD Set key. When using the SPD Set soft key,
One-Touch Speed Calling can be set when the
terminal in an off-hook state (idle), otherwise, it is
invalid.
To Add the One-Touch Speed Calling Key
with SPD Set Key as New Data
STEP 1: Press the SPD Set key.
STEP 2: Press the desired One-Touch Speed Call-
ing key.
STEP 3: Enter the desired phone number (up to 32
digits can be registered).
XXXX
1:25 PM MON 11 MAY 2015
XXXX
1:25 PM MON 13 APR 2015
Note:
A SPD Set key is available for SV9500 V2 or
later.
Note:
A SPD Set key is configured at the installation
stage.
1:25 PM MON 11 MAY 2015
SPD Set Mic NoDist
Push Speed Calling Key
1:25 PM MON 11 MAY 2015
SPD Set Mic NoDist
To Next Page
Loading...
Need help?
General