NetComm NF13ACV User Manual

42
NetComm Wireless AC1200 WiFi Gigabit Router with Voice
www.netcommwireless.com
UM-00013 v1.0
OPTION
DEFINITION
VPN-PPTP server
Enables/disables the PPTP server.
Server virtual IP
Specifies the PPTP server network IP address.
IP pool start address
Specifies the start of the IP pool address range to assign to clients.
IP pool end address
Specifies the end of the IP pool address range to assign to clients.
Authentication protocol
Select the Authentication protocols to use. Options are PAP, CHAP, MS_CHAP and MS_CHAPv2.
MPPE encryption mode
Enables/disables the Microsoft Point-to-Point Encryption protocol.
NAT
Enables/disables network address translation on the PPTP server network.
Encryption length
Selects the level of encryption applied to the tunnel.
Table 14 - PPTP server
Port configuration
The port configuration page provides the ability to manually configure the speed of each of the LAN and WAN ports to 100Mbps full
or half duplex or 10Mbps full or half duplex. When Auto is selected, the NF13ACV selects the highest possible speed that both
nodes are capable of. Selecting Auto therefore prioritizes Gigabit Duplex connectivity.
To access the Port configuration page, click on the Networking menu at the top of the screen then click on the Port configuration
menu item.
Use the drop down lists to select the mode you want the chosen port to operate at. In most cases, it is best to leave these settings
as “Auto” but there may be situations where you want to limit or force a port to behave in a certain manner.
When you have finished making changes, click the Save button to ensure that your changes take effect.

NetComm NF13ACV Specifications

General

Brand	NetComm
Model	NF13ACV
Category	Network Router
Language	English