Network Settings
27
ProSAFE 8-Port and 16-Port Gigabit Web Managed Click Switch
The Switch Information page displays.
5. Select System > LAG > LAG Configuration.
6. Select the LAG ID check box.
7. In the LAG ID menu, select Enable.
8. Select check box 1.
9. Enter the port numbers for LAG 1.
10. Click the Apply button.
Your settings are saved.
11. Select check box 2.
12. Enter the port numbers for LAG 2.
13. Click the Apply button.
Your settings are saved.
Use the ProSAFE Plus Utility to Enable LAGs
You must set up LAG membership before you enable LAGs.
To enable LAGs:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is
of
f-network using an Ethernet cable.
2. Double-click the ProSAFE Plus Utility icon.
The configuration home page displays a list of Web Managed switches that it discovers
on the local network.
3. Select the switch.
If you do not see the switch, click the REFRESH button.
4. Click the APPL
Y button.
You are asked to enter the password for the switch.
5. Enter the switch’
s password in the password field.
The switch’s default password is password.
The Switch Status page displays.
To Next Page
Loading...
Need help?
General
