Menu 7 - Service
OVERVIEW
7.1.1.1 - Temperature setting7.1.1 - Hot water7.1 - Operating settings
7.1.2.1 - Op. mode HM pump GP17.1.2 - Circulation pumps
7.1.2.2 - Pp sp. heating medium GP1
7.1.4.1 - Fan speed, exhaust air
1
7.1.4 - Ventilation
1
7.1.4.2 - Fan speed, supply air
1
7.1.5.1 - Int elec add heat7.1.5 - Add. heat
7.1.6.1 - Max diff supply temp7.1.6 - Heating
7.1.6.2 - Flow settings, climate sys
7.1.6.3 - Power at DOT
7.1.8.1 - Alarm actions7.1.8 - Alarms
7.1.8.2 - Emergency mode
7.1.9 - Load monitor
7.1.10.1 - Operating prioritisation7.1.10 - System settings
7.1.10.2 - Auto mode setting
7.1.10.3 - Degree minute settings
7.2.1 - Add/remove accessories7.2 - Accessory settings
1
7.3.1 - Configure7.3 - Multi-installation
7.3.2 - Installed heat pump
7.3.3 - Name heat pump
7.3.5 - Serial number
7.4 - Selectable in/outputs
7.5.1 - Heat pump, test7.5 - Tools
7.5.1.1 - Test mode
7.5.2 - Underfloor drying function
7.5.3 - forced control
7.5.8 - Screen lock
7.5.9 - Modbus TCP/IP
7.5.10 - Change pump model
7.6 - factory setting service
7.7 - start guide
7.8 - quick start
7.9.1 - Change log7.9 - Logs
7.9.2 - Extended alarm log
7.9.3 - Black box
1
Consult the accessory’s Installer Manual.
MENU 7.1 - OPERATING SETTINGS
Make operating settings for the system here.
MENU 7.1.1 - HOT WATER
This menu contains advanced settings for hot water opera-
tion.
MENU 7.1.1.1 - TEMPERATURE SETTING
Start temperature
Demand mode, small/medium/large
Setting range: 5 – 70 °C
Stop temperature
Demand mode, small/medium/large
Setting range: 5 – 70 °C
Stop temperature periodic increase
Setting range: 55 – 70 °C
51Chapter 9 | Control – MenusNIBE VVM S320
To Next Page
Loading...
Need help?
General
