Nokia 7368 ISAM ONT G-240W-J User Manual

ETSI ONT safety guidelines 7368 ISAM ONT G-240W-J Product Guide
26 3FE-48009-AAAA-TCZZA Issue: 01
3.3.1 Power supplies
The use of any non-Nokia approved power supplies or power adapters is not
supported or endorsed by Nokia. Such use will void any warranty or support contract
with Nokia. Such use greatly increases the danger of damage to equipment or
property.
3.3.2 Cabling
The following are the guidelines regarding cables used for the ONT equipment:
• All cables must be approved by the relevant national electrical code.
• POTS wiring run outside the subscriber premises must comply with the
requirements of local electrical codes. In some markets, the maximum allowed
length of the outside run is 140 feet (43 m). If the outside run is longer, NEC
requires primary protection at both the exit and entry points for the wire.
3.3.3 Protective earth
Earthing and bonding of the ONTs must comply with the requirements of local
electrical codes.
3.4 ESD safety guidelines
The ONT equipment is sensitive to ESD. Operations personnel must observe the
following ESD instructions when they handle the ONT equipment.
Caution — This equipment is ESD sensitive. Proper ESD
protections should be used when you enter the TELCO Access
portion of the ONT.
During installation and maintenance, service personnel must wear wrist straps to
prevent damage caused by ESD.
3.5 Laser safety guidelines
Observe the following instructions when you perform installation, operations, and
maintenance tasks on the ONT equipment.

Nokia 7368 ISAM ONT G-240W-J Specifications

General

Brand	Nokia
Model	7368 ISAM ONT G-240W-J
Category	Touch terminals
Language	English