Introduction
2-3
Part 1032059B
E 2003 Nordson Corporation
Manual 41-DURABLUE-MA-02
1
2
3
Figure 2-1 System components
1. DuraBlue melter
2. Hot melt hose
3. Hot melt handgun
Intended Use
DuraBlue melters are specifically designed to:
S Melt and pump solid-form hot melt materials that are engineered to
be liquified and extruded at temperatures below 230 _C (450 _F) for
240 VAC melters or below 200 _C (400 _F) for 120 VAC melters
S Be used with compatible hot melt hoses and guns that are
manufactured by Nordson Corporation
S Be used in non-explosive environments
Limitations of Use
Use DuraBlue melters only for the purpose for which they are designed.
DuraBlue melters should not be used:
S to melt or pump polyurethane reactive hot melt materials or any
other material that creates a health or safety hazard when heated
S in environments that will require the melter to be cleaned using a
water wash or spray
To Next Page
Loading...
Need help?
General
