scroll key
Operation
4-16
Part 1032059B
E 2003 Nordson Corporation
Manual 41-DURABLUE-MA-02
Adjusting Component Temperatures
You can adjust the set-point temperature of heated components using the
following methods:
S Global—The tank and all hoses and guns are set to the same
set-point temperature.
S Global-by-component group—All of the hoses or all of the guns
are set to the same set-point temperature.
S Individual Component—The set-point temperature of the tank
and each hose and gun is adjusted independently.
Before adjusting set-point temperatures, confirm that each hose/gun pair
is connected to the correct hose/gun receptacle. For example,
hose/gun pair 1 should be connected to the receptacle 1. Refer to More
About Heated Components earlier in this section for information about
hose/gun positions.
To adjust set-point temperatures using the global method
1. Press and hold the Tank key for three seconds.
The left display flashes 1.
2. Scroll the left display to 0 (flashing).
The right display indicates all dashes (----) and the LEDs on all of
the component keys turn green.
3. Press a right-display scroll key.
The right display flashes.
4. Use the right-display scroll keys to enter the set-point temperature
recommended by the manufacturer of the hot melt. Refer to the
technical data sheet provided by the manufacturer of the hot melt to
determine the optimal set-point temperature.
5. Press the Tank key.
All components begin to heat or cool to the new global
set-point temperature. When all of the components reach their
set-point temperature, the ready LED turns on (green).
To Next Page
Loading...
Need help?
General
