Installation
3-12
Part 1032059B
E 2003 Nordson Corporation
Manual 41-DURABLUE-MA-02
Setting Up the Melter
After physically installing the melter, it must be set up to support your
manufacturing process. Melter setup consists of enabling or making
changes to factory-set operating parameters that affect the use and function
of the melter. The operating temperature (set-point) of the tank and each
hose and gun is also established during melter setup.
The melter is shipped from the factory with the most commonly used
operating parameters already set up. The factory setup can be modified at
any time to suit your manufacturing process.
Quick Setup
Table 3-4 describes the most commonly used operating parameters and
their factory settings. Review the table to determine if the factory settings for
each parameter will support your manufacturing process. If the default
values for each of these operating parameters are appropriate for your
manufacturing process, then no melter setup is required.
Go directly to Set-point Temperature of the Tank, Hoses, and Guns later in
this section to complete the installation process.
If you need to make changes to the factory setup or if you want to learn
about other operating parameters, go to the next part in this section,
Operating Parameters.
To Next Page
Loading...
Need help?
General
